Gear Report

Knives, Boards and the Cheap Tool That Makes the Expensive Ones Last

You don't need a knife block. You need two knives, one board, and the twelve-dollar thing nobody buys.

This one links to gear. Gear links may be affiliate links (Amazon); if you buy through one we may earn a small commission at no cost to you. We only list what we'd buy again. Details.

A twelve-piece knife block has about three knives in it you’ll use and nine that take up counter space while they rust. The money is better spent on two good blades, a board that doesn’t fight them, and the one cheap tool that keeps everything sharp between real sharpenings.

Here’s the whole kit. Six things. About two hundred dollars if you spend at the low end, and the low end is fine.

The one knife that does the work

8-inch blade, full tang preferred, about 7 to 9 oz

8-inch Chef's Knife (stamped or forged, your call)

Does 90 percent of the cutting in any kitchen. A forty-dollar one sharpened is better than a two-hundred-dollar one dull.

~$40 to $120 Find it on Amazon

An 8-inch chef’s knife is the right size for almost everyone. Ten inches is for people who cut a lot of brisket. Six inches is for people who don’t own a brisket.

Stamped versus forged is a real distinction with a smaller practical gap than the price suggests. Forged knives are heavier and hold a balance point near the handle. Stamped knives are lighter, often thinner, and easier to sharpen. Both cut onions. Pick the one that feels right in your hand, not the one with the better box.

The verdict is buy it, with a caveat: one. Not a set. One.

The small knife for small work

3 to 4 inch blade, plain edge

3.5-inch Paring Knife

For the work the big knife can't do in hand. Cheap enough that losing one in a cooler isn't a tragedy.

~$10 to $25 Find it on Amazon

Peeling, trimming, hulling a strawberry, cutting the string off a roast. A chef’s knife is too long for anything you do in your hand. A paring knife is the answer, and it is cheap enough that you should own two so one is always clean.

Skip the serrated one unless you cut a lot of tomatoes and refuse to sharpen. A plain edge does everything the serrated one does, and you can maintain it.

The twelve-dollar tool in the headline

10 to 12 inches, ceramic or fine steel, guard at the handle

Honing Rod (steel or ceramic, 10 to 12 inch)

The cheap tool in the headline. Ten strokes a side before you cook and you'll sharpen a quarter as often.

Here’s the thing most people get wrong: honing and sharpening are different jobs.

Sharpening removes metal to make a new edge. Honing pushes a bent edge back into line without removing anything. A knife edge is thin enough that normal cutting rolls it slightly to one side within a few uses. It feels dull. It isn’t. It’s bent.

Ten light strokes per side on a honing rod, about a 15 to 20 degree angle, before you start cooking. That’s it. A knife honed every time you use it needs real sharpening about once a season instead of once a month.

Ceramic rods are a touch more aggressive than steel and work on harder blades. Either one is fine. Both cost about what lunch does.

When honing stops working

Dual-sided, about 7 x 2.5 inches, soak or splash type

Combination Whetstone (1000/6000 grit)

Twenty minutes to learn, a lifetime of sharp knives. The 1000 side does the work; the 6000 side makes it pretty.

Eventually the edge is worn, not bent, and the rod won’t fix it. That’s when you need a stone.

A combination stone with a coarse side around 1000 grit and a fine side around 6000 covers everything a home kitchen needs. Soak it if the instructions say to. Hold the blade at about 15 to 20 degrees, which is roughly the thickness of two stacked quarters under the spine. Twenty strokes per side on the coarse grit, ten on the fine. Wipe it. Paper test.

The first time takes twenty minutes and feels like you’re doing it wrong. By the third time it takes five. The electric pull-through sharpeners work but eat metal fast; a knife that would last thirty years on a stone lasts ten in a grinder.

The board that doesn’t dull the knife

About 18 x 12 inches, 1.5 inches thick, 8 to 12 lbs

End-Grain Wood Cutting Board (large)

Heavy enough not to move, soft enough not to dull an edge. Oil it monthly and your grandkids will argue over it.

Glass and stone boards look clean and destroy edges. Every stroke on a hard surface is a tiny sharpening in the wrong direction. Plastic is better and fine for raw chicken, since it goes in the dishwasher. But for everything else, wood.

End-grain wood, where the fibers point up at the knife, is the gentlest surface you can cut on. The blade slips between the fibers instead of across them. It also self-heals: the fibers close back up over small cuts. A heavy one, 8 pounds or more, stays put on the counter without a towel under it.

The last cheap thing

12 to 16 oz bottle, odorless, won't go rancid

Food-Grade Mineral Oil

Not olive oil. Olive oil goes rancid in a board. This doesn't. Once a month, wipe it on, let it sit overnight.

A wood board dries out. Dry wood cracks, and cracked wood holds bacteria. Once a month, pour a few tablespoons of food-grade mineral oil on the board, rub it in with a rag, and leave it overnight. Wipe off what’s left in the morning.

Not olive oil. Not vegetable oil. Those go rancid inside the wood and you’ll smell it in a month. Mineral oil doesn’t.

The short version

Chef’s knife, paring knife, honing rod, whetstone, wood board, mineral oil. About two hundred dollars. Hone before every use, sharpen once a season, oil the board monthly. Everything on this list will still be working when the twelve-piece block is in a garage sale.

While you're here