How It's Done

How to Dry Out a Flooded Garage Before It Smells Permanent

You have about 48 hours before the mildew sets in. Here's how to spend them.

This one links to gear. Gear links may be affiliate links (Amazon); if you buy through one we may earn a small commission at no cost to you. We only list what we'd buy again. Details.

Garages flood because the slab is at grade and the driveway slopes toward the door. Two inches of rain in an hour, a clogged drain or a gutter dumping at the corner, and there’s water across the floor and up the drywall.

The water itself is a nuisance. The clock is the problem. Mildew starts in about 24 to 48 hours in a warm, wet space, and a Texas garage in August is as warm and wet as it gets. Get the water out and the surfaces dry inside two days, and you’re fine. Wait till the weekend and the smell moves in for good.

1. Kill the power to anything wet

Before you step in, look at where the outlets are. If the water reached a receptacle, an extension cord or the bottom of the fridge, flip the breaker for the garage. Standing water and a live outlet is how a cleanup becomes an ambulance.

If the breaker panel is in the garage and the water is near it, don’t touch it. Call the utility or an electrician. Everything below waits.

2. Get the water out

24 in blade, threaded handle, foam or neoprene

Floor Squeegee (24-inch, foam or rubber)

Moves a hundred gallons out the door faster than any mop. The 18-inch one takes twice as long. Hang it on the wall after; you'll use it again.

Open the big door. Start at the back wall and push toward the driveway in long overlapping strokes. A 24-inch squeegee moves a lot of water fast; a wet vac is slower but gets the last quarter inch the squeegee leaves. If you have both, squeegee first, vac second.

A half-inch of water across a two-car garage is roughly 150 gallons. That sounds like a lot. It’s about twenty minutes with a squeegee and a clear path to the street.

3. Pull everything off the floor

Everything. Cardboard boxes are already ruined; the bottom six inches have wicked water a foot up the sides. Get them into the driveway, salvage what’s inside, and let the boxes go. Rugs and carpet remnants go outside to dry or to the curb. Wood shelving units get flipped on their sides in the sun.

Anything on the slab that stays on the slab stays wet underneath. That’s where the smell will live.

4. Strip the wet drywall

Look at the bottom of the walls. Drywall soaks water up like a wick, and a line of wet will have climbed above the actual high-water mark. Press on it. If it’s soft, it’s done.

Cut it out. Snap a line a foot above the wet mark, score it with a utility knife, and pull it. Pull the wet insulation behind it. Wet fiberglass does not dry inside a wall; it sits there and grows things. Bag it and get it out.

This feels drastic. It’s a four-foot strip of drywall at about fifteen dollars a sheet to replace. Leaving it is a wall that smells for the life of the house.

5. Move air for two days

20 in, 3 speeds, about 2,000 cfm on high

Box Fan (20-inch)

One in the door blowing out, one on the floor pointed at the wet wall. Two cheap fans beat one expensive one every time.

Now dry it. One fan in the open garage door blowing out. One on the floor aimed at the stripped wall. Leave them running. Air movement across a wet surface is what pulls the moisture out; a fan on the slab does more than any amount of waiting.

If it’s humid outside, which it is, a dehumidifier does the heavy lifting with the door closed.

50 pints a day, continuous drain hose, auto shutoff

Dehumidifier (50 pint)

Pulled about 30 pints a day out of a closed two-car garage in August. If you can borrow one from a neighbor for a week, do that. Buy one if this is your third flood.

Closed door, dehumidifier draining into a floor drain or a bucket you empty twice a day, fans circulating inside. Open the door in the heat of the afternoon when outside humidity drops, then close it again at dusk.

6. Clean and don’t rush the rebuild

Once it’s dry, wash the slab and the bottom of the studs with a bucket of water and a cup of plain detergent, then a diluted bleach solution on the framing, about a cup to a gallon, and let it dry again. Then the new drywall, then the stuff back on the floor, on shelves this time, with the bottom shelf six inches up.

Then fix why it flooded. Clean the gutter at that corner, extend the downspout, regrade the strip beside the driveway, or add a trench drain in front of the door. The squeegee is for this time. The grading is for every time after.

The short version

Power off, water out with a squeegee, everything off the floor, cut the wet drywall and pull the insulation, two fans and a borrowed dehumidifier for 48 hours, clean, then rebuild. The smell only wins if you let it sit through the weekend.

While you're here