This one links to gear. Gear links may be affiliate links (Amazon); if you buy through one we may earn a small commission at no cost to you. We only list what we'd buy again. Details.
A cooler’s advertised ice retention is tested indoors, pre-chilled, filled to the top with ice and never opened. Nobody uses a cooler that way. We tested the way people use one: each cooler got two 10-pound bags of ice from the gas station, a 12-pack of cans at fridge temperature, and a spot in the bed of a truck under a tonneau from a Friday afternoon through Monday. Air temperature ran 98 to 104 by day and stayed above 80 at night. Each got opened six times a day for a drink.
Hours below are when the last of the ice was gone and the water was no longer cold enough to matter. Your results will vary with how much you open the lid and how much beer you leave in there.
The one that made it to Monday
Rotomolded Hard Cooler (45 qt class)
Ice at hour 72 in our test. Heavy, expensive, and the one you'll own in fifteen years.
Ice at hour 72. Not a lot of it, but ice, with cans still at fridge temperature Monday morning. Rotomolded means the whole body is one piece of thick plastic with two to three inches of foam in the walls and lid, and a gasket that actually seals. The price is the part that hurts. So does the weight; loaded with ice and drinks it’s a two-person carry.
If you camp, fish, or tailgate more than a few weekends a summer, it’s the right buy. If you don’t, the next one down does the job.
The one most people should own
Injection-Molded Hard Cooler (50 qt class)
About 40 hours of ice for a quarter of the price. Latches and hinges are what fail; the body lasts.
About 40 hours. Ice Saturday night, cold water with chips of ice Sunday noon, warm Sunday evening. For a Friday-to-Sunday trip where you can grab a bag of ice on the way to the lake Saturday, that’s enough. The walls are thinner than a rotomolded, but the lid is insulated, which is the single biggest difference between this class and the one below it.
What fails on these is hardware, not insulation. The plastic latches crack after a couple of summers in the sun and the hinge pins walk out. Both are replaceable. The body is fine for a decade.
The one for a cookout
Basic Hard Cooler (48 qt class, thin lid)
Ice for a day, slush by the second morning. Fine for a cookout. Not fine for a weekend at the lake.
About 20 hours. Ice through Saturday morning, slush by Saturday afternoon, lukewarm water with floating cans Sunday. The lid is a hollow shell and you can feel the cold coming through it with your hand. For a backyard thing where the ice goes in at 3 and the party’s over at 10, it is completely fine. For a weekend, it’s a second and third bag of ice, which over a summer costs more than the next cooler up.
The one real advantage is weight. Eight pounds empty. A kid can carry it.
The one you’ll actually carry
Soft Cooler (24-can class)
About 24 hours in the shade. The one you actually carry to the water. Don't zip it on an empty stomach; the zipper is stiff for a reason.
About 24 hours. Soft coolers can’t match a hard cooler’s insulation, but a good one with closed-cell foam and a welded liner ran a full day and into the next morning in the shade. In direct sun, cut that in half.
This is the cooler that goes from the truck to the chair to the boat. The hard cooler stays in the bed as the mothership and this one gets refilled from it. That system beats one giant cooler every time.
The thing that stretches all of them
Reusable Ice Blocks (hard-shell)
Won't keep a cooler cold alone. Under a layer of real ice they bought every cooler here 6 to 10 extra hours.
Hard-shell ice blocks alone won’t keep a cooler cold through a weekend; they don’t have the mass. But frozen solid and set on the bottom under a layer of cubed ice, they bought every cooler here 6 to 10 extra hours. Block ice melts slower than cubes because it has less surface area. The reusable ones just don’t leave a swamp.
If you have the freezer room, freeze a few gallon jugs of water instead. Same effect, free, and you can drink them Sunday.
The short version
Rotomolded if it’s your hobby, injection-molded with an insulated lid if it’s your weekend, basic if it’s your backyard. Add a soft cooler to carry, block ice under the cubes, and stop opening the lid to look.